Chassis - Frame

D+D rigid frame is a basic starter frame featuring a 1-1/4 inch steel tubing with a 1-1/2 inch backbone 30° rake and 0° stretch for XL models with ...

Knucklehead frame is an authentic reproduction of the factory style bull neck frames with numbered forgings seat post junction rear motor mount fro...

Frame insert has a spider web design with a raw finish. Inset is 1/4 inch thick with a 7 inch square profile. Fitment: 0 Custom

200 XL rigid frame features a 40° rake with a 3 inch stretch. Frame can be set up for 1957-1985 type Ironhead motors. Frame will accept 1 inch neck...

Frame insert has a Maltese design with a raw finish. Insert is 1/4 inch thick and has a 7 inch square profile. Right angle allows to be cut for nec...

Front engine mount weld on frame brace fits rigid frames for replacement and repair. Features a raw steel finish. This is an update design heavier ...

Replica straight leg rigid frame is for chain drive models. This frame is an authentic reproduction of the 1954-1957 straight leg frame with a stoc...

Replica XL swingarm frame will accept rear belt drive and Evolution engines. Frame will utilize 1997-up oil tank swingarm bearing kit for use with ...

OEM #: 47003-41, 2802-41 Knucklehead rigid frame with a 29° rake neck angle is an authentic reproduction of the factory style featuring 12 brazed j...

OEM #: 47003-41, 2802-41 Knucklehead rigid frame is an authentic reproduction of the factory style frame. Includes seat post assembly transmission ...

Replica swingarm frame will accept belt drive and disc type brakes. This XLH frame will accept all XL type engines 1983-up oil tank and bearing kit...

Replica inchHM inch straight leg rigid frame is an authentic reproduction of the 1954-1957 straight leg frame with stock 30° neck rake. Features cr...

Replica frame is an authentic reproduction of the factory style featuring 13 brazed joints. The 28° rake neck angle will accept inline spring forks...

Lowered rear axle plates are threaded 3/8 inch-18 for fender brace sissy bar mounting. Adjusters threaded 3/8 inch-24 use screws for adjusters to a...

Cadmium rigid frame bung is 3/8 inch-16 thread and includes a zinc 3/8 inch-16 x 1-1/7 inch hex bolt and 3/8 inch split lock washer. For use on rea...

Replica inchHM inch wishbone frame features full inchhallmarks inch on forgings. Does not include indents or horn mounts on wishbone front legs. Ne...

Replica inchHM inch wishbone frame features full inchhallmarks inch on forgings. Frame is an authentic reproduction of Replica Wishbone frame is an...

Replica inchHM inch wishbone frame features full inchhallmarks inch on forgings. Includes horn mount tabs on wishbone tubes. Hallmarks forged with ...

Replica Knucklehead frame is a reproduction of the factory style frame. Frame includes seat post brake cross shaft rear axle assembly transmission ...

Raw replica swingarm frame is an authentic reproduction of FLH style for 1958-1964 kick start models only. Swingarm is a non-electric start and is ...

Replica swingarm frame is an authentic reproduction of FLH style for 1965-1984. Frame accepts Panhead or Shovelhead engine 4-speed transmission 12v...

Replica swingarm frame is our authentic reproduction of FLH style to accept a Panhead or Shovelhead engine 4-speed transmission seat post and accep...

This replica authentic style frame neck web repair section must be welded in after cutting stock or custom frame. It features the right side lock h...

Casting top seat mount is for frame seat post frame back bone and frame upper seat rail yoke constructed of forged raw steel. Bushing and grease fi...