Tools

Linkert hand tool tap 5/16 inch X 32 thread. Fitment: 1941-1965 FL

Linkert hand tool tap 5/16 inch X 18 thread. Fitment: 1941-1965 FL

Linkert hand tool tap 12-24 thread. Fitment: 1941-1965 FL

Linkert hand tool tap 10-32 thread. Measurements: Overall Length: 3.9370 inches Shank Diameter: 0.4375 inches Fitment: 1941-1965 FL

Cam bearing puller tool removes the inner cam needle bearing #9057 without splitting the cases while preventing the rollers from coming out during ...

Cam bearing remover tool allows the removal of needle bearings while keeping the needles from falling into the engine. For use with bearing as list...

This four piece tool safely installs the inner cam bearings to the proper depth in the case without damaging bearings. Complete 8 piece tool set in...

Jims #: 975 This Jims shaft turning tool fits spline or taper on assembled motor and allows engine to be turned over by 1/2 inch ratchet or impact ...

Jims #: 959 Using the special Jims precision insert this tool is designed to easily and accurately convert the left side crank roller bearing to th...

Wheel bearing install tool is to be used with 25mm bearing including ABS and non ABS bearings. *NOTE: Required to use with the wheel bearing puller...

Jims #: 965 This tool removes the starter ring gear rivets from clutch shells. Fitment: 1990-2006 FLST 1990-2006 FLT 1991-2005 FXD 1990-2006...

Jims #: 973 This excellent tool upgrades Jims bearing installer tool for work on fine splined Twin Cam sprocket shafts. Allows for installation of ...

Jims #: 972 This tool allows for perfect installation of the main drive gear oil seal on the assembled transmission to its proper depth. The protec...

Jims #: 968 This Jims 3 piece gasket locator tool will properly align the primary cam and transmission end cover gaskets that will prevent misalign...

Jims #: 2315 The Jims primary locking tool is used to lock the clutch hub sprocket to the front engine sprocket. It also allows the removal or torq...

Jims #: 998 Jims right side drive transmission access door puller tool removes the access door on all right sided drive transmissions. Fitment: 20...

Jims #: 995 Use this tool to expertly and safely break the case sealant by pushing apart both halves. This tool bolts to the primary mounting holes...

Jims #: 994 The cam locking tool allows the removal and torquing of cam sprocket bolts by locking camshaft and camshaft sprockets. Fitment: 2007-2...

Glide fork nut double ended wrench feature a black oxide finish. Used for removing and installing crenulated nuts and dust covers with internal thr...

Jack shaft lock wrench is zinc plated. This tool is used to hold starter gears on 1991-up Big Twins. Fitment: 1991-UP FL 1991-UP FLT 1991-UP F...

This eight piece set features exact replicas of tools as available to dealers in the early days. Fitment: 1936-1952 EL 1941-1984 FL 1941-1957 ...

Jims #: 1390 The cam gear remover tool is used to remove the cam gear from the camshaft. The tool acts as a stable base to keep the camshaft perpen...

Jims #: 1290 This alignment tool is designed to index the cam gears position while removing on installing the cam gear. You will be able to accurat...

Jims #: 1280 The Jims cam bearing puller tool is used to remove the bearing from the crankshaft and is designed to do this with no slipping or bind...