Electrical - Magneto

Volt Tech #: 78023 Hobbs hour meter is a round type for 12 volt 2 cylinder applpications. The meter calculates the total amount of hours an engine ...

Cast aluminum magneto housing is die cast as original with a natural finish and has rare earth magnets cast in. Bare housing with key lock hole pro...

Cast aluminum magneto housing is die cast as original with a natural finish and has rare earth magnets cast in. Bare housing without key lock hole ...

OEM #: 92077-62 Magneto tachometer plug kit includes plug pin cottter pin and o-ring. Fitment: 1962-1969 XL

Left hand magneto points base plate. Left hand rotation is opposite of the standard Harley rotation. Fitment: 1936-1952 EL 1941-1969 FL

XR/XL/WR magneto drive assembly includes gears and related mount plates for 45 inch motors when installing a front mount magneto in place of the ge...

Volt Tech #: 77936 Magneto vent cap set includes two screens cups screws and lock washer. Two pieces as required in Fairbanks Burkhardt Joe Hunt an...

Magneto base drive assembly includes base plate shoulder screw set with flex lock nuts for direct mount to cam cover on models listed and the shaft...

Joe Hunt #: P32 Joe Hunt Magneto advance assembly. Fitment: 1970-1984 FL 1986-1992 FLST 1980-1992 FLT 1971-1984 FX 1982-1992 FXR 1984-19...

XL Replica magneto driveshaft assembly comes assembled with hex top gear and cast iron base with white zinc finish. Cast iron base with pre-install...

Magneto adapter plate has built in studs for timing adjustment slots in magneto shaft assembly. Includes four machined screws and two studs pressed...

Joe Hunt #: 138 Left hand magneto point set for left hand counter clockwise rotation. Fitment: 0 Replacement

Joe Hunt #: 4008 Left hand magneto rotor for left hand counter clockwise magnetos features a 3/8 inch hex drive. . Fitment: 0 Replacement

Volt Tech #: 1274LB This manual advance magneto is prepared and set up to increase performance and reliability for left hand counter clockwise rota...

Magneto rotor collar includes bearing and is for use with XR models. *NOTE: Must order inner magneto mount plate separately. Notes:Suggested to use...

XR/WR inner magneto mount plate with the magneto adapter screw set allows magneto to rotate on mount plate to adjust timing and magneto position. F...

Magneto kit features a drive shaft with hex end and spiral grooves with a snap ring on the shaft for the tachometer drive. Also includes drive gear...

Burkhardt magneto cap kit includes vintage copper cloth wire set. Used for all Joe Hunt Burkhardt Fairbanks-Morse and Morris magnetos. Fitment: 195...

Red magneto top cover has brass contacts molded in and includes gasket and screws. Top cover fits Fairbanks Morse and most aftermarket units. The s...

Volt Tech #: 63622 Magneto kill switch button is for use on Fairbanks Morse Morris and Joe Hunt units. Fitment: 1959-1970 XLCH

Magneto base drive assembly includes base plate shoulder screw set with flex lock nuts for direct mount to cam cover on models listed. This feature...

OEM #: 29600-56R XR/WR magneto adapter plate mounts the magneto to the generator position on 45 W and G engines featuring a machined alloy construc...

Magneto point and kill switch kit. Fitment: 1959-1969 XL

Assembly includes Magneto head and adjustable advance. Magneto base has the 2-hole mount flange like 1941-69 type distributors on 1941-1969 FL mode...